MSA Cairns 880 Instrucciones De Instalación página 7

(6) To install the chin strap so the closure is on the right,
do the following:
a) On the left side of the impact cap, pull up on the
b) Install the section of the chin strap with the QRB
c) Connect both snaps. Make sure that the snaps are
d) With the section of the chin strap with the Postman's
Note:
(7) If necessary, replace the squares of hook-and-loop
material (included in replacement kit) on the impact
cap.
(8) Replace any damaged hardware, such as screws,
retention lugs, and nuts (included in replacement kit).
(9) Install the impact cap from the back of the helmet. Make
sure that the snaps for the chin strap are below the
retention lugs.
MSA Cairns Helmets - Chin Strap Replacement Kits
overhead suspension to lift the plastic tubing.
under the tubing.
closed tightly and the snap covers point outward,
away from your skin.
buckle, do steps a. through c. on the right side of the
helmet.
To install the chin strap so the closure is on the left,
install the chin strap with the QRB on the right side of
the helmet and the chin strap with the Postman's
buckle on the left side of the helmet.
Installation
US
7