Installing The Microphone - Sony XAV-AX200 Manual De Instrucciones

Power connection diagram
Check your car's auxiliary power connector and
match the connections of cords correctly
depending on the car.
Auxiliary power connector
Common connection
Red
Yellow
continuous power
12
supply
15 switched power supply
When the positions of the red and yellow
leads are inverted
Red
Yellow
12 switched power supply
continuous power
15
supply
For cars without ACC position
Red
Yellow
After matching the connections and switching
power supply leads correctly, connect the unit to
the car's power supply. If you have any questions
and problems connecting your unit that are not
covered in this manual, consult the car dealer.
Red
Yellow
Yellow
Red
Red
Yellow
Yellow
Red
Red
Yellow

Installing the microphone

To capture your voice during handsfree calling, you
need to install the microphone .

Clip (not supplied)
Cautions
• It is extremely dangerous if the cord becomes
wound around the steering column or gearstick.
Be sure to keep it and other parts from interfering
with your driving operations.
• If airbags or any other shock-absorbing
equipment are in your car, contact the store where
you purchased this unit or the car dealer before
installation.
Note
Before attaching the double-sided tape , clean the
surface of the dashboard with a dry cloth.
Using the wired remote control
When using the steering wheel remote
control
Installation of the connection cable RC-SR1 (not
supplied) is required before use.
1
To enable the steering wheel remote control, select
[General Settings]  [Steering Control Custom] to
make the registration (page 14).
When the registration is complete, the steering
wheel remote control becomes available.
Notes on installing the connection cable RC-SR1 (not
supplied)
• Refer to the support site on the back cover for details then
connect each lead properly to the appropriate leads.
Making an improper connection may damage the unit.
• Consulting the dealer or an experienced technician for
help is recommended.
When using the wired remote control
1
To enable the wired remote control, set [Steering
Control] in [General Settings] to [Preset] (page 14).


29
GB