Operating Instructions; Remote Control; Care And Maintenance - Harbor Breeze 00878 Manual De Instrucciones

OPERATING INSTRUCTIONS

Note: If you have more than one remote controlled fan installed in
the same location, you may want to change the frequency of the
remote control to avoid any possible interference between remote
controls. To change the frequency of the remote control, change
the dip switch settings as described below:

1. REMOTE CONTROL:

(1) Install Battery/Learning Process:
Remove the battery cover from the back of the remote
found in the remote pack (L). Insert the battery from the
remote pack (L) into the remote; ensure polarity of battery
matches the polarity indicated in the battery compartment
-- positive (+) to positive (+) and negative (-) to negative (-).
Replace the battery cover.
If you need to change the dip switches in the remote control
due to a potential interference issue, slide the dip switches
to your choice of either up or down -- the factory setting is
up. Within 30 seconds of turning the fan's power on, press
and hold the "Learn" button on the remote control for 1
second. Once the receiver has detected the set frequency,
the light of the fan will blink twice. Replace the battery
cover. To confirm the remote control and receiver have
paired successfully press any of the fan speed control
buttons on the remote control.
(2) Fan Control / Dimmer:
0 Low speed
0 0 Medium speed
0 0 0 High speed
O Turns fan off
Turns light on or off
For the DIMMER function, press and hold the
is at desired level.
Note: This remote control has a memory function. The receiver stores the fan speed and light setting
when the fan is turned off. When fan is turned on again, it starts with the most recent settings.
L
Learn key
Dip switch
button. Light will dim. Release the button when light
Lowes.com/harborbreeze
12
2. REVERSE SWITCH:
When the season changes, you may want to change the
direction the fan blades spin. To switch between clockwise
and counterclockwise rotation, flip the fan reversal switch.
WARNING: Wait for fan to stop before reversing switch.
• In warmer weather, counterclockwise rotation creates a
downward airflow, which cools the air. Push the switch
LEFT and see a Sun icon.
• In cooler weather, clockwise rotation creates an upward
airflow, which moves hot air from the ceiling into the room.
Push the switch RIGHT and see a Snowflake icon.
L
OPTIONAL: If desired, the wall bracket in remote pack (L)
can be installed to house the remote control. Remove the
small plate preassembled on the wall bracket and use the
screws in remote pack (L) to secure the wall bracket at
desired mounting location. Replace the small plate, then
rest the remote control into wall bracket.

CARE AND MAINTENANCE

• IMPORTANT: Shut off main power supply before beginning any maintenance.
• DO NOT use water or a damp cloth to clean the ceiling fan.
• At least twice each year, tighten all screws and lower the canopy to check mounting bracket
screws and downrod assembly.
• Clean fan housing with only a soft bristle brush or lint-free cloth to avoid scratching the finish.
Clean blades with a lint-free cloth. You may occasionally apply a light coat of furniture polish
to wood blades for added protection.
• Bulb replacement: Use 40-watt max. candelabra-base E12-type incandescent bulbs; CFLs and
LEDs are not recommended for this item.
• Battery replacement: Use an A23 12-volt alkaline battery for the remote control.
1
Snowflake icon
Sun icon
Small plate
Screws
Wall bracket
Lowes.com/harborbreeze
13