Marmitek GIGAVIEW820 Modo De Empleo página 6

• If the GV820 set is in Standby mode (POWER LED is red), press the ON/OFF button on the
GV820 Transmitter and Receiver to switch them on. It takes about 80 seconds for the
system to start up.
• While warming up, the Power LED will flash blue until the signal connection between the
Transmitter and Receiver has been established.
NOTE: the Transmitter and Receiver must be at least 2 metres apart to have a
good connection.
3. Set the HDTV or HD projector (in HDMI mode) and the HD device that you wish to watch ON.
4. Press the SOURCE button until you see the video images from your device. The time it
takes to switch between sources may be about 15-20 seconds.
5. If you have electrical equipment, such as wireless telephones or internet, that work on
the 5GHz frequency it may impact upon the sound and picture quality of the GV820 set.
Press the CHANNEL button on the Remote Control in order to select another channel (see
'Channel Frequency' appendix for an overview).
6. If everything is working correctly, the POWER LED and SOURCE LED will be constantly
blue (see table if this is not the case).
6
CHANNEL
WIDE MODE
ON / OFF
SOURCE
1 - 2
INFO
POWER
CHANNEL
WIDE MODE
ON / OFF
MARMITEK