Fcc Compliance - Chauvet DJ D-Fi Hub Guía De Referencia Rápida

FCC Compliance

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the
user is encouraged to try to correct the interference by one or more of the following measures:
(1) Reorient or relocate the receiving antenna.
(2) Increase the separation between the equipment and receiver.
(3) Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
(4) Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority to
operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
Contact
Outside the U.S., U.K., Ireland, Benelux, France, Germany, or Mexico, contact your distributor to request support or
return a product. Refer to
What is Included
• D-Fi Hub
• Power supply
To Begin
Unpack your D-Fi Hub and make sure you have received all parts in good condition. If the box or contents appear
damaged, notify the carrier immediately, not Chauvet.
Description
The D-Fi Hub is a transmitter and receiver that either receives D-Fi signals and transmits via a DMX cable, or receives
data via a DMX cable and transmits D-Fi signals. It wirelessly synchronizes an unlimited number of D-Fi-ready fixtures
and receivers simultaneously. It is small and compact with sturdy antenna. Built-in options include manual or automatic
channel selection. Mounting options include a built-in hook and loop fastener strap, keyhole mounting holes and threaded
mounting holes. The D-Fi Hub is fully FCC/RTTE compliant.
Overview
Antenna
storage
DC power
input
DMX in
DMX out
D-Fi Hub QRG Rev. 3
QUICK REFERENCE GUIDE
Contact Us at the end of this QRG for contact information.
• Quick Reference Guide
Display
Control
buttons
EN
Antenna
2