Troubleshooting Tips - Kwikset Touchpad Electronic Deadbolt Instalación E Instrucciones De Uso Manual Del Propietario

Troubleshooting Tips

If Electronics Are Not Working —
Check the Following:
Are your batteries good? Is the power strip
plugged in properly? (See step 4.6)
Are the batteries installed correctly and mak-
ing full contact? (See step 4.8) You should
hear a series of quick beeps when batteries
are installed correctly and making full contact.
Handing of Your Door
If the bolt does not extend when lock button is
pressed, check the handing of your door (See
Step 4.9)
Preset Factory Codes
This lock will maintain two different codes.
Two random codes are preset by the factory
for testing. It is recommended that you enter
two new security codes to cancel out the
preset codes. (See step 5).
Problems with Setting your Security Codes
— Check the Following:
You will hear a 2 second beep when your
codes are accepted. (See step 5.1-3).
If the unit does not beep — too much time has
elapsed between steps 1 & 2. Repeat these
steps faster.
Note: You have approximately 3 seconds
between step 1 & 2 for your codes to be
accepted. Please note the next statement.
Unauthorized Code Warning:
For your added security, a warning tone will
sound for 15 seconds if an incorrect security
code is entered three times consecutively. The
Touchpad will not operate for 1 minute.
Note: If several attempts were needed to
set your security codes — you may have
activated the warning sound. Wait 1 minute
for the unit to be operational again.
Important Note:
Manual locking or unlocking the
deadbolt by turning the key or the T-
turn — the motion will be firm. This
resistance is normal for this lock.
For assistance call
1-800-327-5625 USA
or visit www.kwikset.com
9