Door Preparation; Deadbolt Latch Installation - Kwikset Touchpad Electronic Deadbolt Instalación E Instrucciones De Uso Manual Del Propietario

1. Door Preparation

Replacement Installation
1 Remove all old lock
components.
2 Use the enclosed template
to verify the following:
• Deadbolt face hole needs to
be 2-1/8" (54mm) diameter.
• Backset – Distance from
edge of door to center of
lock (2-3/8 or 2-3/4").
• Location to drill the small starter holes for
inside and outside trims.
• Make any necessary modifications.
First-time Installation
Follow instructions on enclosed template.
2
2. Deadbolt Latch Installation (Piece B)
To Adjust Backset:
Rotate to a 2-3/4" (70mm)
position, if required.
U
P
Preparation for latch with Face Plate
1
Keeping edges parallel to the face of the door,
outline face plate and remove deadbolt latch
(see illustration below left).
2
Chisel outline of face plate until it is flush with
door edge, 5/32" (4mm) deep (see illustration
below right).
Install Latch
For latch with face plate:
With bolt extended, insert deadbolt latch in
1
edge hole. Be sure to keep the word "UP" at
top. Secure with two 5/8" wood screws.