Strike Installation - Kwikset Touchpad Electronic Deadbolt Instalación E Instrucciones De Uso Manual Del Propietario

For Drive-In latch:
1 With bolt retracted, insert deadbolt latch into
edge hole keeping flat edge of bolt parallel to
the edge of door. Be sure to keep the word
"UP" at top.
2
Using a wood block, tap with hammer until
surface of collar is flush with door edge
Re-extend bolt.
P
U
3. Strike Installation (Piece C)
First-time Installation
1
Draw a horizontal centerline across the door
jamb, the same distance from floor as is the
centerline of deadbolt latch.
2 Measure back from door stop, 1/2 the
distance of the door thickness and draw a
vertical centerline. At crosspoint, drill a 1-1/8"
diameter (28.5mm) hole,1-1/4" (29mm) deep,
in the door jamb.
1/2 of door
thickness
Door
Jamb
Center strike over hole and trace around
3
strike. Chisel out door frame until strike is
flush.
Position strike with large holes toward door
4
stop. Pre-drill large holes 3" (76mm) deep.
Door
Stop
Install strike
1 Install 3" (76mm) screws in large strike holes
and install remaining 5/8" wood screws in
smaller holes.
Close door and ensure bolt extends and
2
retracts freely.
Important Note:
Deadbolt latch must enter strike
with no resistance or the Power-
bolt Touchpad Electronic Deadbolt
will not work properly.
3