Programming Instructions - Kwikset Touchpad Electronic Deadbolt Instalación E Instrucciones De Uso Manual Del Propietario

4. Touchpad Electronic Deadbolt Installation
Retract deadbolt latch B with T-turn. Press the lock button on Touchpad A. If motor runs but
9
latch does not extend: Door handing needs to be changed. To change door handing, remove
jumper (located in the upper right corner of the circuit board) from position "A" and plug it into
position "B". See illustrations.
Left hand
Right hand
Door
Door
Exterior
From Exterior:
• If hinge is on the left, you
have a left hand door.
If hinge on the right, you
•
have a right hand door.
10 Verify key works in deadbolt E.
Note: When manually locking or unlocking the deadbolt by turning the key or the T-turn:
The motion will be firm — this resistance is normal.
6

5. Programming Instructions

1 Push program button on Power Board H once. 2 Enter desired 4 to 8 digit code by pressing
numbers on outer Touchpad A. Press the
Lock button on Touchpad to set your code.
3 You will hear a 2-second long beep when your
code is accepted.
If unit does not
beep — too much
time has elapsed
between steps
1 and 2. Repeat
steps 1 and 2
faster.