Stihl MS 170 Manual De Instrucciones página 28

: Unscrew the nuts and take off the
chain sprocket cover.
5
: Turn screw (4) counterclockwise
until the tensioner nut (5) butts
against left end of housing slot.
MS 170, MS 180, MS 180 C
: Disengage the chain brake: Pull
hand guard (6) toward front handle.
4
Wear work gloves to protect your
hands from the sharp cutters.
: Fit the chain – start at the bar nose.
6
9
: Fit the guide bar over the studs (7) –
cutting edges on top of bar must
point to right – and engage the
peg of the tensioner slide in locating
hole (8) –- place the chain over
sprocket (9) at the same time.
: Now turn tensioning screw (10)
clockwise until there is very little
chain sag on the underside of the
bar –- and the drive link tangs are
located in the bar groove.
: Refit the sprocket cover –
and screw on the nuts only finger-
tight.
: Go to "Tensioning the Saw Chain".
English / USA
7
7
10
8
27