Setting Up The Bronze Fx - Monitor Audio Bronze Serie Manual Do Utilizador

Setting up the Bronze FX

The Bronze FX's are paired, but specifically, right hand and left hand units. Of which both can be configured
to bi-pole (normal operation) or di-pole modes. The factory setting is bi-pole.
In bi-pole mode, all speaker units (mid/ bass unit and tweeters) are in phase. This feature is designed for
when the Bronze FX is set up as a rear/surround speaker in a typical 5.1 channel system, or alternatively in
a 7.1 channel system without a second pair of FX's for rear/ surround duties.
In di-pole mode, the front firing tweeters are out of phase with the other tweeter and mid/bass unit. It is
best to implement this configuration when using two pairs of FX's as part of a 7.1 channel system, with the
FX's taking up positions on the side and rear walls. Please note that they are left and right handed. This
is not an issue when used in bi-pole mode. It is essential that they are positioned correctly if used in a 7.1
channel system. Please refer to the positioning section on page 4 and the following images. In all cases
experimentation is advised to get the best set up for you.
NOTE: Before changing your Bronze FX's from bi-pole mode to di-pole mode, please ensure
that the amplifier is turned off. This protects the amplifier and speakers.
Bi-Pole Bi-Pole
Di-Pole Di-Pole
LEFT
5.1 system with surround speakers on the side wall
(floorstanding/ stand mounters can also be used).
monitoraudio.com
Bi-Pole Bi-Pole
Di-Pole Di-Pole
RIGHT
5