Disconnecting The Charger - auto XS CPL-2054U Manual Del Usuario

USA
Operation
• the indicator for the battery charge level
while the fields that are full indicate existing capacity; blank fields indicate
missing charge).
The frame around the battery symbol will blink during the charging process
(see fig. E).
Once the battery is fully charged,
• all fields of the battery symbol are full and the frame will be shown continu-
ously in the indicator.
• The voltage indicator will show CHA (see fig. F).
The charger will switch to trickle charge to maintain the battery's charge level.

Disconnecting the charger

WARNING!
Danger of explosion!
Improperly disconnecting the charger may produce sparks. An
explosion may be triggered by highly explosive detonating gas
resulting from the charging process.
− Always disconnect the charger from the grid first.
− Follow the correct order of steps when disconnecting the
battery terminal clamps (+/-) from the battery or chassis.
The order of steps for disconnection corresponds to the reverse order of steps
for connecting the charger:
1. Pull the power plug out of the socket.
2. If you charged the battery outside of the vehicle, disconnect the
1. black battery terminal clamp
first,
2. the red battery terminal clamp
tery afterwards.
If you charged a battery built into the car, disconnect the
1. battery terminal clamp connected to the chassis first and
2. the battery terminal clamp connected to the battery afterwards.
You have successfully disconnected the charger.
20
customer-service@wk-usa.com
11
(indicates the charge level
5
from the negative pole (-) of the battery
4
from the positive pole (+) of the bat-
AFTER SALES SUPPORT
1 888 367 7373
USA