Intended Use; Product Description - Quick QCC DRV 4CV Manual De Instalacion Y Uso

CHARACTERISTICS / INSTALLATION / OPERATION
EN

INTENDED USE

• The QCC-DRV 4CV is intended to be used in nautical applications to control the colour and adjust the brightness of
RGBW LED light sources in constant voltage.
• For fire-prevention reasons, install the QCC-DRV 4CV in a ventilated, controlled-temperature environment, protected
from dust and humidity. Do not expose the dimmer pack to rain or humidity.
• Always provide a fast-working 3A fuse on the device's power supply to protect its electronics.
• Any other use should be considered improper and unpredictable.
F
READ THESE INSTRUCTIONS CAREFULLY BEFORE USING THE PRODUCT. IN CASE OF DOUBT, CONTACT
YOUR DEALER OR QUICK
THE PACKAGE CONAINS: QCC-DRV 4CV - conditions of warranty - the manual of installation and use.
ELEMENTI TECNICI E DEFINIZIONI
• RGBW LED light sources: in this specific manual, these are lighting devices inside which there is a RGBW LED. Each of
the four channels is to be driven in constant voltage.
• Control signal: In this specific manual, it is the electrical signal generated by the QCC-PLT 300 and which contains the
necessary information for the QCC-DRV 4CV driver operation.

PRODUCT DESCRIPTION

The QCC-DRV 4CV is a module to adjust light intensity and colour in a RGBW
system.
This function is active only if the device is coupled and appropriately connected to
Quick QCC-PLT 300.
®
INSTALLATION
• The device must be placed in a suitably protected distribution board so that it can operate under the environmental
conditions indicated in the general specifications for use, and is not within reach of personnel who are not qualified.
• Always disconnect the supply voltage during installation and maintenance operations.
• Make the connections following the best practices, using cable of adequate type and size that are appropriate for the
environment conditions.
• Critically inspect your work immediately after installing or servicing the product.
OPERATION
The QCC-DRV 4CV receives an input control signal on two wires from the QCC-PLT 300 by Quick
power and the instructions to be turned in constant voltage power for the four output channels.
These four channels in constant voltage drive the LED RGBW light sources. With electrical installation at 12V, each QCC-DRV
4CV drives up to a load of 30W, while to 24V up to 60W.
Wiring, terminals and cables
Considering the high currents involved, a few precautions on wiring are in order:
• the maximum length of the wires used for the control signal (2 cables bus without polarity) is 100 metres (328'); use
cables with a maximum cross section of 2.5mm
• To connect the QCC-DRV 4CV to the RGBW LED light sources use wires suitable to support the present load; for the max-
imum load, a 5x0,75mm
relevant color to be switched on).
CUSTOMER SERVICE.
®
2
cable is advised (black common positive wire and 4 colored negative wires, each one of the
2
(0,1') suitable for the load applied.
8
QCC-DRV 4CV - REV002A
, from which it receives the
®
QUICK SPA