Product Safety Labels - 3M MP8795 Guía De Seguridad Del Producto

The following safety labels are used on or within the MP8795 projector to alert you to items or areas requing your
attention:
In some countries, the line voltage is NOT stable. This projector is designed to operate
safely within a bandwidth of 90 to 132 volts / 198 to 264 volts (50 to 60 Hz) ± 10 volts ,
Caution
but could fail if power drops or surges of ±10 volts occur. In these high-risk areas, it is
recommended to install a power stabilizer unit.
C A U T I O N
LASER RADIATION-
DO NOT STARE INTO BEAM
MAX. OUTPUT: 1mW
WAVE LENGTH: 650nm
CLASS2 LASER PRODUCT
LASER RADIATION
DO NOT STARE INTO BEAM
CLASS2 LASER PRODUCT
MAX. OUTPUT: 1mW
WAVE LENGTH: 650nm
IEC60825-1 : 1993+A1:1997
SAVE THESE INSTRUCTIONS
The information contained in this manual will help you operate and maintain your 3M MP8795 Multimedia Projector.
6
Location of Product Safety Labels
Complies with 21 CFR 1040. 10 and 1040. 11 except for deviations
pursuant to Laser Notice No.50, dated 2001.7.26
SMK CORPORATION
6-5-5 Togoshi Shinagawa-ku, Tokyo, JAPAN 142-8511
MANUFACTURED Novemver 2001
PLACE OF MANUFACTURER: A
3M™ Multimedia Projector MP8795 Product Safety Guide
HIGH TEMPERATURE / HAUTE TEMPERATURE / HOCHTEMPERATUR /
ALTA TEMPERATURA / ALTA TEMPERATURA
1 2
3 4
When replacing lamp, turn off and unplub unit, wait 45 minutes to let lamp cool.
High-pressure lamp when hot, may explode if improperly handled.
Pour changer la lampe, éteindre et débrancher la machine. Attendre 45 minutes de maniére
á laisse tefroidir la lampe. La lampe haute pression risque d'exploser si elle est manipulée
sans précaution lorsqu'elle est encore chaude.
Vor Austausch der Lampe, das Gerät abschalten und den Stecker herausziehen; 45 minuten warten,
warten, um die Lampe abkühlen zu lassen. Falls die heiße Hochdrucklampe falsch gehandhabt wird, kann sie explodieren.
Prima di sostituire la lampadina, spegnere il proiettore, scollegarne la presa di alimentazione ed attendere
45 minuti circa che la lampadina si raffreddi. Se calda, essa è sottoposta ad alta pressione interna e puó esplodere.
Cuando tenga que reemplazar la lámpara, desconecte la alimentación y desenchufe la unidad, y espere 45 minutos
para dejar que se enfrié la lámpara. La lámpara, que está a alta presión cuando está caliente,
quede explotar si se manipula indebidamente.
AVOID EXPOSURE-
LASER RADIATIONS IS
EMITTED FROM THIS
APERTURE
5 6 7
12
6
© 3M 2003