Publicidad
Idiomas disponibles
Idiomas disponibles
Installation and operation
1.
Measure the width of the opening where you
intend to install the gate. Please refer to this
measurement to determine the correct
installation configuration.
Preparation for Use
Attaching the two gate panels
1. To begin setting the appropriate width of the
gate, unscrew and remove the upper panel
assembly fitting (P/N 2) and lower panel
assembly fitting (P/N 3).
2. Set the appropriate width of the gate by
overlapping the two panels to the extent
necessary to allow room for the spindles (parts
10 & 11) on either side of the gate.
The maximum allowable overlap is seven bars.
The minimum allowable overlap is two bars.
3. Re-install the upper and lower panel assembly
fittings on the upper and lower rails.
Insert two screws (P/N 13) into the upper panel
assembly fitting and tighten them.
Page 3
Publicidad
