Publicidad
Idiomas disponibles
Idiomas disponibles
4. Repeat step 3 for the lower panel assembly fitting.
Mounting the hinges
5. Hold template (A) against the surface to
which the gate is to be fitted (hinge side).
• Ensure that the template is vertical,
completely outstretched, and that the end
marked " " is on the floor.
Mark the screw hole positions.
6. Remove the template. Install the two hinges
using P/N 14 screws with the post pointing
upwards as shown in figure 6 at right.
Mounting upper latch/latch housing
7. Hold template (B) against the surface to
which the gate is to be fitted (latch side).
• Ensure that the template is vertical,
completely outstretched, and that the end
marked " " is on the floor.
Mark the screw hole positions.
Hinge
Handle
latch side
Page 4
Publicidad
