Method Of Operation; Maintenance Instructions - Makita RBC2500 Instrucciones De Manejo Originales

Method of operation

– Only use the Brush cutter/String trimmer in good light and visibility. During the
winter season beware of slippery or wet areas, ice and snow (risk of slipping).
Always ensure a safe footing.
– Never cut above waist height.
– Never stand on a ladder and run the Brush cutter/String trimmer.
– Never climb up into trees to perform cutting operation with the Brush cutter/ String
trimmer.
– Never work on unstable surfaces.
– Remove sand, stones, nails etc. found within the working range.
Foreign particles may damage the cutting tool and can cause dangerous kick-
backs.
– Before commencing cutting, the cutting tool must have reached full working
speed.
– If grass or branches get caught between the cutting tool and guard, always stop
the engine before cleaning. Otherwise unintentional blade rotation may cause
serious injury.
– Take a rest to prevent loss of control caused by fatigue. We recommend to take a
10 to 20-minute rest every hour.
Kickback (blade thrust)
– When operating the brush cutter, uncontrolled kickback may occur.
– This is particularly the case when attempting to cut within a blade segment
between 12 and 2 o'clock.
– Never apply the brush cutter within a segment between 12 and 2 o'clock.
– Never apply this segment of the brush cutter blade to solids, such as bushes
and trees, etc., having a diameter in excess of 3 cm or the brush cutter will be
deflected at great force with the risk of injuries.
Kickback prevention
To avoid kickbacks, observe the following:
– Operation within a blade segment between 12 and 2 o'clock presents positive
hazards, especially when using metal cutting tools.
– Cutting operations within a blade segment between 11 and 12 o'clock, and
between 2 and 5 o'clock, must only be performed by trained and experienced
operators, and then only at their own risk.
Easy cutting with almost no kickback is possible within a blade segment between
8 and 11 o'clock.
Cutting Tools
Employ only the correct cutting tool for the job in hand.
RBC2500 with cutter blade (Star Blade (4 teeth), Eddy Blade (8 teeth)), RBC2510
with Nylon cutting head.
Never use other blades including metal multi-piece pivoting chains and flail blades.
Otherwise serious injury may result.
For cutting thick materials, such as weed, high grass, bushes, shrubs, underwood,
thicket etc. (max. 2 cm dia. thickness). Perform this cutting work by swinging the
brush cutter evenly in half-circles from right to left (similar to using a scythe).

Maintenance instructions

– Have your equipment serviced by our authorized service center, always using
only genuine replacement parts. Incorrect repair and poor maintenance can
shorten the life of the equipment and increase the risk of accidents.
– The condition of the cutter, in particular of the cutting tool of the protective devices
and also of the shoulder strap must be checked before commencing work.
Particular attention is to be paid to the cutting blades which must be correctly
sharpened.
– Turn off the engine and remove spark plug connector when replacing or
sharpening cutting tools, and also when cleaning the cutter or cutting tool.
All manuals and user guides at all-guides.com
5
12
2 Caution:
Kickback
Diagrammatic
Diagrammatic
figure
figure