Depth Stop; Inserting / Removing Tools; Quick-Release Chuck For Round Shaft Drills; Setting The Function With The Function Selector Switch - Parkside PBH 1050 B2 Traducción Del Manual De Instrucciones Original

Start-up

Depth stop

Open the wing screw
Insert the depth stop
handle .
7
Make sure that the toothing on the depth stop
is pointing downwards.
Pull the depth stop
so that the distance between the tip of the drill
and the tip of the depth stop corresponds to
the desired drilling depth.
Firmly tighten the wing screw

Inserting / removing tools

Inserting tools:
Lightly grease the tool holder
ing the tool.
To insert, pull back the locking sleeve
insert the tool.
Release the locking sleeve
tool holder. Pull the tool to ensure that it is firm-
ly locked in place. The tool has some radial play
inherent in the system.
Removing tools:
To remove the tool pull back on the locking
sleeve .
10
Quick-release chuck for
round shaft drills
Do not use the quick-release
chuck for round shaft drills for hammer drilling or
chiseling applications!
Set the function selector switch
symbol .
Attaching the quick-release chuck for
round shaft drills:
To attach the additional chuck for round shaft
drills (also see Fig. A) pull back the locking
sleeve and insert the additional chuck.
10
40 GB/MT
.
1
in the additional
11
out as far as necessary
11
.
1
before insert-
8
and
10
. This locks the
10
to the drill
6
Release the locking sleeve
holder. Pull the tool to ensure that it is firmly
locked in place.
Removing the quick-release chuck for
round-shaft drills:
11
To remove the additional chuck pull back the lock-
ing sleeve
10
Inserting tools:
device off and unplug from the mains socket before
performing any work on the device.
Setting the function with the
function selector switch
Press and hold the release button for the function
selector switch
switch until the desired symbol locks in next
6
to the arrow.
The functions are marked as follows:
Function
Drilling / screwing
Hammer drilling
Chiseling
Chisel position
adjustment
Adjusting the chisel position:
This function allows you to turn the tool to the nec-
essary position for chiseling (also see Fig. C, D).
Turn the function selector switch
.
Turn the tool inside the tool holder
necessary position.
To chisel, turn the function selector switch
. This locks the tool
10
and remove the additional chuck.
RISK OF INJURY! Switch the
and turn the function selector
6 a
Symbol
to position
6
8
to the
to .
6