Prepare The Hood; Install The Hood - Broan Elite E662 Instrucciones De Instalación

5. PREPARE THE HOOD

5.1 Remove filters from the hood. Remove (3) screws holding both side
panels to the hood and set aside. Remove both side panels.
5.2 Punch out 2 knock-out holes for electrical connections (2 on top or one on top and one on back of the hood).
5.3 Attach one wire clamp on top of the hood for the provided electrical cable with 3-prong plug. Through the wire
clamp, insert this electrical cable in the hood and tighten the wire clamp to secure the cable.
5.4 Connect cable wires as follow: BLUE wire with red connector to BLUE
wire with red connector (A), BROWN wire with red connector to BLACK
wire with red connector (B), GREEN wire under ground screw (C).
DO NOT FORGET TO CONNECT THE GROUND.

6. INSTALL THE HOOD

6.1 Run power cable to installation location. Position the hood in its intended location. Using a pen, mark the position
of the screws (smaller part of the keyholes, see pictures below for the (5) keyholes locations). Remove the hood.
6.2 Install (4) #8 x 1 ⁄ '' screws, leaving a
2
1
2
HD0127
1 ⁄ '' gap (do not install the #5 screw yet).
8
1
2
HD0129
- 4 -
S
CREW
HO0042
B
A
C
HE0052
3
3
5
4
HD0128
L
OCATIONS
4