For Your
Information
Precautions
Troubleshooting Guide
Maintenance
Specifications
Index to Parts and Controls
Index
Precautions
If you have any questions or problems
concerning your stereo system, please
consult your nearest Sony dealer.
On safety
•The unit is not disconnected from the AC
power source (mains) as long as it is
connected to the wall outlet, even if the
unit itself has been turned off.
•Unplug the system from the wall outlet
(mains) if it is not to be used for an
extended period of time. To disconnect
the cord (mains lead), pull it out by the
plug. Never pull the cord itself.
•Should any solid object or liquid fall into
the component, unplug the stereo system
and have the component checked by
qualified personnel before operating it
any further.
•The mains lead must be changed only at
the qualified service shop.
On installation
Place the stereo system in a location with
adequate ventilation to prevent heat build-
up in the stereo system.
On condensation in the CD player
component
If the system is brought directly from a cold
to a warm location, or is placed in a very
damp room, moisture may condense on the
lens inside the CD player. Should this
occur, the CD player will not operate.
Remove the CD and leave the system
turned on for about an hour until the
moisture evaporates.
To save a tape permanently
To prevent a tape from being accidentally
recorded over, break off the cassette tab
from side A or B as illustrated. If you later
want to reuse the tape for recording, cover
the broken tab with adhesive tape.
Side A
Tab of side A
Tab of
side B
When you are using a type II (CrO
be careful not to cover the detector slots
which allow the tape player to
automatically detect the type of tape.
TYPE II
Detector slots
Troubleshooting
Guide
If you run into any problem using the
stereo, use the following check list and first
check the following points:
• The mains lead is connected firmly.
• The speakers are connected correctly and
firmly.
Should any problem persist after you have
made the checks below, consult your
nearest Sony dealer.
Tuner
"STEREO" flashes in the display.
Adjust the aerial.
Severe hum or noise.
Adjust the aerial.
The signal strength is too weak.
Connect the external aerial.
Connect the ground wire.
A stereo FM programme cannot be
received in stereo.
Press STEREO/MONO so that
"STEREO" appears.
Tape Player
The tape does not record.
No tape in the tape compartment.
The tab has been removed from the
cassette.
The tape has reeled to the end.
The tape does not record nor
playback or there is a decrease in
sound level.
The heads are dirty. Clean them.
Magnetic deposits have built-up on
the record/playback head*.
There is excessive wow or flutter, or
the sound drops out.
The capstans or pinch rollers are
contaminated*.
) tape,
2
The tape does not erase completely.
Magnetic deposits have built-up on
the record/playback heads*.
Noise increases or the high
frequencies are erased.
Magnetic deposits have built-up on
the record/playback heads*.
* See "Maintenance."
continue to next page
EN
21
For Your Information