Inspection & Maintenance - flamco LS-E Instrucciones De Instalación Y Funcionamiento

The seal tightness of the system as a whole must be checked under normal operating
conditions and during maintenance and, if necessary, the flange couplings must be
tightened. Check the safety valve at regular intervals.
The boiler must be included in the potential equalisation.
Temperature control/gauge:
The temperature sensor in the heating control unit and, if applicable, the solar-power
controller and/or thermostat sensor must be fitted in the appropriate plunge pipe. The
height of the plunge pipe determines the switching point for reheating. The temperature can
be read from the thermometer supplied. It is to be fitted on the front of the unit in the G ½"
fitting.
4. Inspection & maintenance
No liability shall be accepted for damage that is caused by failure to follow the installation
and operating instructions.
The boiler must be installed to allow easy access for maintenance, operation, repairs or
replacement. Site preparation and suitability for installation of the vessel are not the
responsibility of the manufacturer or the responsible distributor. Furthermore, facilities for
the secure drainage of the boiler in the event of any water leakage must be provided to
avoid water damage.
If the local water is highly calciferous, a commercial de-calcifier can be fitted before the
potable water part of the system. Natural calcification is not the boiler manufacturer's
responsibility.
If in doubt please consult the manufacturer.
Dirt traps are recommended for both mains water and hot water systems. They must be
serviced regularly depending on the system conditions.
Sources of electro-chemical corrosion, such as mixing systems, must be avoided.
Removal
Once cooled, depressurize the system and remove the product from the system.
Local legislation must be adhered to when disposing of the various components.
6