Important Safety Instructions; Safety Alert Symbol; Specifications - BriskHeat HotBelt HB1001 Manual De Instrucciones

IMPORTANT SAFETY INSTRUCTIONS

SAFETY ALERT SYMBOL

The symbol above is used to call your attention to
instructions concerning your personal safety. It points out
important safety precautions. It means "ATTENTION!
Become Alert! Your Personal Safety is involved!" Read
the message that follows and be alert to the possibility of
personal injury or death.
DANGER
A person who has not read and understood all operating
Instructions is not qualified to operate this product.
DANGER
•
Do not immerse heater in liquid.
•
Keep volatile or combustible material away from
heater when in use.
•
Use heater only in approved locations.
•
Keep sharp metal objects away from heater.
•
Do not modify this product. Modification will void
warranty.
Failure to observe these warnings may result in electric
shock, risk of fire, and personal injury.
WARNING
End-User Must Comply to the Following:
•
The end-user is responsible for providing suitable
electrical protection device. It is highly
recommended that a ground fault circuit breaker is
used.
Failure to observe these warnings may result in personal
injury or damage to the heater.
®
© BriskHeat Corporation. All rights reserved.
HotBelt™
Wrap Around Refrigerant Jug Warmer
DANGER
Immediate hazards which WILL result in severe personal
injury or death.
WARNING
Hazards or unsafe practices that COULD result in severe
personal injury or death.
CAUTION
Hazards or unsafe practices that COULD result in minor
personal injury or property damage.
CAUTION
•
Inspect heater before use (see page 7).
•
Do not use product if any component is damaged.
•
Do not repair a damaged or faulty component.
•
Do not crush or apply severe physical stress on
any component of system.
•
Unit must be mounted away from vibration,
impacts, water and corrosive gases.
•
Fasten heater to the cylinder using approved
methods only.
Failure to observe these warnings may result in personal
injury or damage to the heater.
3

SPECIFICATIONS

Voltage
Part Number
(+/- 10%)
HB1001 (US) 120
HB2001 (US) 240
HB2002 (EU) 230
•
Fits standard cylinders sizes: 30lb, 50lb, and 125lb
•
Built-in controlling thermostat
•
Max exposure temperature: 450°F (232°C)
•
Thermostat closes: 147°F +/-16°F (64°C +/-9°C)
•
Thermostat opens: 158°F +/-9°F (70°C +/-5°C)
•
Width: 6" (152mm)
•
Length: 26" (660mm)
•
Adjustable strap length: 17" (432mm)
•
Fits minimum cylinder diameter: 9" (229mm)
•
Fits maximum cylinder diameter: 13" (330mm)
•
Power Cord: 6 ft (1.8 m)
•
Grounded heating element
•
Total Watts: 200W
•
Ingress Protection Rating: IP56
•
Max humidity: 95%
•
Acceptable for use with R-410A, R-407C, R134a, R-22. R-404, and more.
®
© BriskHeat Corporation. All rights reserved.
HotBelt™
Wrap Around Refrigerant Jug Warmer
Plug Type
NEMA 5-15
NEMA 6-15
CEE 7/7
4