Troubleshooting Guide; Warranty Information - BriskHeat HotBelt HB1001 Manual De Instrucciones

Inspection:
•
Inspection should be performed after the heater has cooled to room temperature and with the
electricity disconnected.
•
The heater should be free of any cuts, cracks, or punctures.
•
The power leads should not have any visible breaks in their insulation
•
The heater should be free of any build-up of dirt, oil, grease, or other foreign matter.
Storage:
•
This product should be stored indoors.
Disposal:
•
This product does not contain any hazardous substances and may be discarded with domestic
waste.

TROUBLESHOOTING GUIDE

Please read this guide prior to contacting BriskHeat
commonly asked questions. If you are unable to identify the problem or need additional assistance,
please contact your local distributor/ representative or us at
1-800-848-7673, 614-294-3376, or bhtsales1@briskheat.com.
PROBLEM SOLUTION(S)
Does not heat Verify heater is connected to proper voltage. The identification label
located on the power cord displays the heater's voltage requirement.
Using an ohm meter, check to see if there is a resistance
reading (not an open circuit) in the heater.
Circuit breaker is tripping Validate that the circuit breaker is capable of handling the amp
requirement of heater. The identification label located on the power cord
displays the heater's amperage requirement.
Examine heater and cord for any damage.
Does not fit Confirm that the heater provided was designed to fit around your
container (see page 4).
If the heater was designed for your container, please contact BriskHeat
factory for further assistance 1-800-848-7673 or
614-294-3376.
®
© BriskHeat Corporation. All rights reserved.
HotBelt™
Wrap Around Refrigerant Jug Warmer
®
. This guide is designed to answer the most
7

WARRANTY INFORMATION

BriskHeat warrants to the original purchaser of this product for the period of eighteen (18) months from
date of shipment or twelve (12) months from date of installation, whichever comes first. BriskHeat's
obligation and the exclusive remedy under this warranty shall be limited to the repair or replacement, at
BriskHeat's option, of any parts of the product which may prove defective under prescribed use and
service following BriskHeat's examination, is determined by BriskHeat to be defective. The complete
details of the warranty can be found online at www.briskheat.com or by contacting us at 1-800-848-7673
(toll free, U.S. / Canada) or 1-614-294-3376 (Worldwide).
Corporate Headquarters:
4800 Hilton Corporate Dr.
Columbus, OH 43232, U.S.A.
Toll Free: 800-848-7673
Phone: 614-294-3376
Fax: 614-294-3807
Email: bhtsales1@briskheat.com
®
© BriskHeat Corporation. All rights reserved.
HotBelt™
Wrap Around Refrigerant Jug Warmer
Europe:
P.O. Box 420124
44275 Dortmund, Germany
8