Continuous Drainage - Impecca IDM-40SE Manual De Usuario

opeRaTInG InsTRUCTIons (ConTInUeD):
ReMovInG The ColleCTeD WaTeR:
There are two ways to remove collected water .
1. Use The ReseRvoIR
• When the unit is off,if the reservoir is full, the unit will beep 8 times
and the Full indicator light will flash, the digital display shows P2 .
• When the unit is on, if the reservoir is full, the compressor turns off
and the fan turns off after 30 seconds for drying the water of the
condenser, then the unit will beep 8 times and the Full indicator
light will flash . The digital display shows error P2 .
• Slowly pull out the reservoir . Grip the left and right handles securely,
and carefully pull out straight so water does not spill . Do not put the
tank on the floor because the bottom of the reservoir is uneven . If
the reservoir is balanced on the floor, it will fall and water will spill .
• Throw away the water and replace the reservoir . The reservoir must
be in place and securely seated for the dehumidifier to operate .
• The machine will re-start when the reservoir is correctly positioned .
• noTes: When you remove the reservoir, do not touch any parts in-
side of the unit . Doing so may damage the product . Be sure to push
the reservoir gently all the way into the unit . Banging the reservoir
against anything or failing to push it in securely may cause the unit
to stop operating . If water spills or is found within the unit upon
removing the reservoir, you must dry it .

1. ConTInUoUs DRaInaGe

Water can be automatically emptied into a floor drain by attaching
the unit with a water hose (5/16" diameter) with a 1" female thread-
ed end .
• Install the drain hose onto the adaptor A (see Figure C) .
• Remove the plastic cover from the back drain outlet of the unit and
set aside and remove reservoir,then insert the drain hose through
the drain outlet of the unit and securely press it into the connector
on the front of the unit . (see Figure E)
• Tighten the adaptor A and the unit by using two screws (placed in
the reservoir) .
• Install the female threaded end of the water hose into the adaptor A
(see Figure F), then lead the water hose to the floor drain or a suitable drainage facility .
• Make sure the hose is secure so there are no leaks . Direct the hose toward the drain,making sure that
there are no kinks that will stop the water flow . Place the end of the hose into the drain and make sure
the end of the hose is level or down to let the water flow smoothly . Do never let it up .
• Place the reservoir back in the unit and make sure that it is seated correctly .
• Select the desired humidity setting and fan speed on the unit to commence continuous draining .
6