How To Operate Your Ceiling Fan - Fanimation The Embrace 44 Manual Del Propietário

4. Assemble the socket plate assembly to the light plate
assembly using the previously removed screws. (Figure 4)
5 (Option A--for use with light kit)
Insert light bulb into socket. (Figure 5A)
CAUTION
To reduce the risk of fire, use 100-watt max. type
T4-minican JD E11 tungsten halogen bulb. Turn off
the wall switch and allow the bulb to cool for 10
minutes before relamping.
Bulb is pressurized and may shatter. DO NOT
TOUCH BULB WITH BARE HANDS. Fingerprints
may result in shorter bulb life. Remove fingerprints
with alcohol prior to use.
NOTE: If you have installed your fan with the steel cap,
skip steps 5.
6. Secure the glass to light plate assembly by twisting
in a clockwise direction. Do not over-tighten. (Figure 6)
1. Operating and using hand-held remote (Figure 1):
Install two 3-volt batteries (included). If not using for long
periods of time, remove battery to prevent damage to
transmitter. Store the hand-held remote away from excess
heat or humidity.
How to Assemble the Light Kit (continued)

How to Operate Your Ceiling Fan

Light Plate Assembly
Light Bulb
Socket Plate
Assembly
Figure 5A
Light Plate
Assembly
Glass
3
V, CR2032
BATTERY
2PCS
REMOTE
CONTROL
11
Socket Plate
Assembly
Figure 4
Steel Cap
Assembly
Figure 5B
Figure 6
Figure 1
Light Plate
Assembly