Daily Operation - Holman QCS Serie Instrucciones De Instalación Y Operación

GENERAL INSTALLATION DATA
INSPECTION & ASSEMBLY
UNCRATING AND INSPECTING
Unpack the unit and components from the shipping container. Remove
all visible packing material and those from inside the cooking chamber. If
damage is discovered, fi le a claim immediately with the carrier that handled
the shipment. Do not operate the unit if it was damaged during shipping.
ASSEMBLY AND INSTALLATION
The unit was shipped fully assembled and ready to plug into a standard
outlet specifi ed for its voltage and amp draw. Before making any electrical
connection to this unit, check that the power supply is adequate for the
voltage, amperage and requirements stated on the rating plate. If improper
electrical supply is determined, contact a qualifi ed electrician prior to using
the unit.
Level unit using the adjustable feet under the unit (approximately 1/2"
adjustment).
Before using the unit for the fi rst time, wipe down the exterior with a damp
cloth.
Allow enough space around the toaster for adequate ventilation. Do not
operate the unit without the crumb tray properly positioned. Overheating
and poor toasting may occur. Read all labels on the unit and follow their
instructions.

DAILY OPERATION

Set the heat control knobs to desired temperature.
Always allow 10 minutes of preheat time before loading the unit with product.
Failure to allow suffi cient preheat time will result in unsatisfactory cooking
until the unit reaches operating temperature.
ROTARY POWER SAVER SWITCH
For toasters equipped with a Rotary Power Saver Switch, turn clockwise
or counterclockwise to get in the following positions.
FULL POWER
When in this position your equipment
is at full power and ready to use.
OFF ROTARY
Two off positions are provided, a single
rotation to either direction will shut the
unit off.
STANDBY
The standby position reduces
the power consumption by 75%.
Using this position during the quiet
times will save electricity, and
keep the toaster warm.
needed, turn the switch to FULL
POWER. Recovery time is about
30 seconds.
When