Astralpool 43395 Manual De Instalación Y Mantenimiento página 2

ENGLISH
IMPORTANT: The instruction manual you are holding includes essential information on the safety measures to be
implemented for installation and start-up. Therefore, the installer as well as the user must read the instructions
before beginning installation and start-up.
Keep this manual for future reference.
For optimum performance of the BOLERO.ND AUTOMATIC POOL CLEANER, we recommend you to read the following instructions.
1. CHECK THE CONTENTS OF THE BOX
You will find the following articles inside the box:
1. Main body
2. Mat
3. Base
4. Deflector
5. Counterweight x 2
6. Conical adapter
7. Flow metre
8. Flow control
9. Hoses x 12
10. Installation and maintenance manual
2. GENERAL FEATURES
• BOLERO.ND hydraulic suction cleaners use the filtering
system of the pool as the source of energy. They are
connected to the skimmer or the pool cleaner inlet.
• The power of the swimming pool pump enables them to move automatically at random, and suction the dirt. These will be stored in the prefilter
of the pump and in the filter, and therefore we recommend regular cleaning of the pump pre-filter.
3. INSTALLATION AND POSITIONING
When installing the POOL CLEANER, it is recommended to use ¾ HP pumps. The membrane impels the water several times per second and it is
therefore subject to wear. The efficiency of BOLERO.ND is based largely on the condition of the membrane, which should be checked regularly
ASSEMBLING THE MAT
You will find the mat at the bottom of the box.
Press the mat turning it at the same time. Perform the same operation with the base.
ASSEMBLY OF THE HOSES
The BOLERO.ND hose is formed by 1-metre sections.
The length of the hose to be used, which will adapt perfectly to the pool, is equal to the longest distance the cleaner must move in the pool from
the connection point + 1 section of hose.
In swimming pools with ladders where the suction point is in front of the steps, take the
lower step as the most distant point.
Always insert the male terminal in the female terminal. The hoses should be connected and
properly tightened.
Use the CONICAL ADAPTER to connect the hose to the suction point. Its range is from 40 to
60 mm. in Ø.
Any other type of hose will reduce the performance of the cleaner. Never use a continuous self-floating hose.
We advise you to leave the BOLERO.ND in the pool during the summer. If you wish to remove it while bathing, dismantle the hose and keep it
stretched out. Do no roll it or expose it to the sun.
ASSEMBLING THE ACCESSORIES
DEFLECTOR
This prevents the BOLERO.ND from becoming stuck in corners, ladders or steps.
Fit the DEFLECTOR in the hose in the best position so that the pool cleaner does not become
stuck in obstacles in the pool, at about 50 cm. from the BOLERO.ND.
COUNTERWEIGHT
This offsets the floating capacity of the hose and ensures that the BOLERO.ND is well balanced
at the deepest part of the pool.
2
.