Troubleshooting - Astralpool 43395 Manual De Instalación Y Mantenimiento

CHANGING AND REPLACING THE MAT
TURN OFF THE PUMP AND DISCONNECT THE POOL CLEANER FROM THE HOSE

7. TROUBLESHOOTING

PROBLEM
The BOLERO.ND
does not work
The BOLERO.ND
moves very slowly and bubbles of air
appear in the return nozzle
The BOLERO.ND
is stuck in the ladders and in the steps of
the ladders
6. Place the membrane in the transparent tube with the flange, and place the membrane cover.
Insert the unit inside the pool cleaner.
7. Screw the connection tube and the three screws of the membrane cover.
8. Install the BOLERO.ND and start-up the pump.
1. Remove the base by pulling outwards and turning at the same time.
2. Remove the mat from the BOLERO.ND by pulling outwards.
3. Replace the mat (4406012404) with a new one by turning it in place.
It is recommended to place the base with a turning movement.
Install the BOLERO.ND and start-up the pump.
Check that the membrane is not blocked. If it is, remove the solid debris inside the suction
•
cavity.
Check the flow using the flow metre
•
•
•
is insufficient:
IF THE
•
FLOW
•
is correct:
•
Check the water tightness of the circuit: between the apparatus and the hose, between all
•
sections of the hose, between the hose and the valve, between the valve and the skimmer.
Place the deflector in the best position to avoid blocking and let it adapt to the shape and the
•
obstacles of the swimming pool.
This problem can be solved in some cases by connecting the hose to the suction intake or the
•
skimmer that is furthest away from the ladder, or cut 1 section of hose to stop it reaching the
steps
5
SOLUTION
Check that the drain valve is properly closed.
Check that the filter, the pump prefilter and the skimmer basket
are completely clean.
Ensure that the hose and automatic control are properly connected.
Check that the suction system of the apparatus is not blocked.
Check that the membrane is not blocked or torn.