Important Safety Precautions - Heco DIREKT 800 BT Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 28
Dear HECO Customer,
Congratulations on your fine new loudspeakers and thank you very much for choosing HECO! You have made an
excellent choice. The high-quality speakers produced by HECO are renowned all over the world.
Please study the instructions and information below carefully before using your new loudspeakers.

IMPORTANT SAFETY PRECAUTIONS

Please read through the instruction manual carefully before starting to use the device. This manual contains
important information concerning operation and safety aspects. It is imperative you observe all of the
information. Keep the manual in a safe location.
• WARNING NOTICES: All of the warning symbols on the speakers, accessories and in the instruction manual itself
must be adhered to.
• EXPOSURE TO HEAT: Only operate the speakers and accessories in a temperature range from 5°C to 40°C.
The speakers should not be positioned near heat sources (heaters, ovens, radiant heaters, naked flames, etc.).
When setting up close to an amplifier a minimum distance of 10 cm must be maintained.
• EFFECT OF MOISTURE: The speakers should not be exposed to dripping or splash water. Neither should they be
used to support vases or other containers filled with liquid. Do not expose the speakers to water or high levels of
humidity. There is a danger of electric shock. In the event of contact with moisture or liquids remove the mains
adapter immediately.
• FOREIGN MATERIAL: Ensure that no foreign material enters through the speaker openings and into the interior.
This could trigger short circuits and even result in electric shock and fire.
• CLEANING: Please use a soft, dry cloth with no cleaning agents, sprays or chemical solvents, as these could
damage the surfaces.
• ELECTRICAL CONNECTION: Please note the voltage levels on the information sign. The mains adapter for the
speakers should only be operated with the voltage and frequency values specified on the sign.
• LIGHTNING PROTECTION/PREVENTIVE MEASURES: If the device is not going to be used for a prolonged period
(e.g. when on holiday), it should be disconnected from the mains by removing the plug. The device should also be
disconnected from the mains in the event of a thunderstorm. Doing this will prevent damage caused by lightning
and overvoltage.
• MAINS CABLE: The mains cable must always be suitable for operation and it should only ever be laid out in a
manner that prevents it from being trodden on. It should not be pinched by objects either, as this can damage
the cable. When using plugs and power strips it must be ensured that the cable is not kinked at the point where it
emerges from the socket. Do not connect or remove the mains cable with damp hands.
• OVERLOAD: Sockets, power strips and extension cables should not be overloaded. If an overload occurs, there is a
risk of electric shock and fire.
• The speakers should only be positioned or mounted on a solid surface and not on moving base frames, otherwise
there is a risk of injury.
• Batteries (battery pack or batteries installed) shall not be exposed to excessive heat, such as sunshine, fire and the
like.
CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or equivalent type.
DAMAGE THAT MUST BE RECTIFIED BY A SPECIALIST:
If any of the following damage occurs, disconnect the speaker from the mains immediately and contact a specialist to
conduct the repair work:
Damage to the mains cable or the mains plug.
A damaged cable should not be repaired, but must be replaced.
If moisture or water has entered the device or foreign objects have fallen into the device.
If the speaker has fallen and the housing is damaged.
If the device does not work properly, even though all of the information in the instruction manual has been
observed.
Only those subsequent alterations approved by the manufacturer may be conducted.
Only original spare parts should be used for repair.
After conducting any repairs the safety of device should be checked to ensure it is functioning correctly and safely.
Repairs must always be conducted by qualified specialists, as you might otherwise be exposed to dangerous high
voltage levels or other hazards.
10

Publicidad

Tabla de contenido
loading

Tabla de contenido