Unpacking - Ryobi RY48ZTR75 Guía De Armado

 Remove the bolts securing the corner and side braces
to the frame bottom, then lift the braces to remove.
 Cut the nylon straps securing the front and rear wheel
axles to the frame.
 Remove boxes containing loose parts, assembly hardware,
and documentation.
 Remove and set aside all accessible packaging and wrap
from unit and parts. Do not discard the packing material
until you have carefully inspected and satisfactorily oper-
ated the product.
WARNING:
If any parts on the Loose Parts List are already as-
sembled to your product when you unpack it, verify the
part is assembled correctly, is properly tightened, and is
torqued correctly (where applicable) before proceeding
to the next assembly step. Use of a product that may
have been improperly assembled could result in death
or serious personal injury.
 Inspect the product carefully to make sure no breakage
or damage occurred during shipping.
 If any parts are damaged or missing, please call
1-800-860-4050 for assistance.

UNPACKING

NOTE: Mower should be assembled while positioned on
the frame bottom. Once assembly is complete, raise the
cutting deck to its highest position, position a ramp next to
the frame bottom, release the parking brake and slowly and
carefully drive mower off frame.
WARNING:
Use extra care when driving the mower off of the frame.
Press the low speed drive button and carefully move the
drive levers and/or press the brake pedal as needed to
control the speed. When driving the mower off of the
frame, do not exceed the maximum recommended op-
eration angle of 15°. Failure to follow these instructions
can result in loss of control and result in death, serious
personal injury, or property damage.
NOTICE:
If no ramp is available, slowly and carefully drive the
mower off the frame in reverse while looking down and
behind. Driving the mower off the frame in the forward
direction without a ramp can cause damage to the
mower's cutting deck.
4 — English