Home Decorators Collection 51472 Guía De Uso Y Cuidado página 12

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Assembly - Attaching the Light Kit
13
Installing the light bulbs
WARNING: Do not overtighten when installing the glass shade
into the light kit assembly. Allow the glass shade to cool
completely before removing.
WARNING: Over lamping the fan will result in the fan lights
shutting down until the proper wattage of bulbs are installed.
Reset the lights by turning off lights, replacing the bulbs with the
correct wattage bulbs, and turning the lights back on.
Remove the bottom cover and finial from the threaded nipple
of the light kit fitter assembly (H).
With power off, install the three incandescent bulbs (Max.
60W, included) (J) by screwing them into the light bulb
sockets.
Position the glass bowl (I) over the threaded nipple.
Re-install the bottom cover to the threaded nipple to secure
the glass bowl (I) properly.
Re-install and tighten the finial.
J
14
E
H
I
12
Assembling the fan without a light
kit
Remove the three light kit mounting screws (FF) on the
switch cup adaptor (G).
In order to use the fan without the light kit, remove the switch
cup (NN) from the top of the light kit fitter assembly (H) by
removing the center hex nut inside the switch cup (NN), and
then thread the switch cup (NN) off of the threaded nipple on
the top of the light kit fitter assembly (H).
Press the plastic plug (CC) into the center hole of the switch
cup (NN).
Position the switch cup (NN) on to the switch cup adaptor (G).
FF
E
G
NN
CC

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

1000 022 303

Tabla de contenido