Troubleshooting; Safety Notices - Caso SMG20 Manual De Instrucciones Original

Ocultar thumbs Ver también para SMG20:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 127
• Smells can be removed from the oven by mixing a cup of water with the juice and the
skin of a lemon, pouring this into a deep microwave-proof bowl and allowing it to cook
in Microwave mode for five minutes. Then, dry off the oven thoroughly with a soft cloth.
• After cleaning the interior space, leave the oven door open until the interior of the device
is completely dry.
• Cleaning hint – If there are cooked food residues stuck to the inside walls of the oven,
there is an easy way to clean these: Place half a lemon into bowl, add 300 ml water
and microwave this for 10 minutes at full power. Then simply wipe the inside of the
appliance clean with a soft and dry cloth.
Front of device and operating panel
• Clean the front of the device and the operating panel with a soft, slightly damp cloth.
• Please bear in mind that the operating panel does not get wet. Use a soft, damp cloth
for cleaning.
► Leave the oven door open to prevent the device from being re-started accidentally.
Exterior housing
• Clean the exterior surfaces of the device with a damp cloth.
Turntable, grating and rolling ring
• The accessories (turntable, grating and rolling ring) must occasionally be removed and
cleaned. Wash the accessories in warm soapy water.
• The rolling ring should be cleaned regularly to prevent excessive noise development or
a rotational malfunctions.
The rolling ring can be washed in a mild soapy solution . Please remember to put the
rolling ring back again properly after cleaning it.
• Wipe the bottom of the oven with a mild cleaning agent. If the floor of the oven is
excessively dirty, you can use a mild cleaning agent.

15 Troubleshooting

This chapter provides you with important notices with regard to operating the device.
Observe the following notices to avoid dangers and damages:

15.1 Safety notices

► Only qualified electricians, who have been trained by the manufacturer, may carry out
any repairs on electrical equipment.
► Improperly performed repairs can cause considerable dangers for the user and
damages to the device.
caso SMG20
Please note
Attention
67

Publicidad

Tabla de contenido
loading

Tabla de contenido