Mark THEATRE 300 Manual De Uso página 2

dangers like short-circuit, burns, electric shock, lamp explosion, crash etc.
Replacing the lamp
♦ DANGER TO LIFE! Only install the lamp with the device switched off! Unplug from mains before!
♦ CAUTION! The lamp has to be replaced when it is damaged or thermally deformed due to the heat!
The lens must be replaced if it is visibly damaged and therefore operating with reduced efficiency.
♦ Before replacing the lamp, unplug mains lead and let the lamp cool down (approx. 5 minutes).
♦ During the installation do not touch the glass-bulbs bare-handed! Please follow the lamp
manufacturer´s notes!
♦ Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the
device was not designed for. Damages caused by non-observance are not subject to warranty.
♦ For the installation, you need one GY 9.5 halogen lamp with up to max. 300/500W
♦ Procedure:
Step 1:Unscrew the handle screw on the rear of the device.
Step 2: Push out the cover to the back.
Step 3: Remove the old lamp.
Step 4: Insert the same type lamp into the lamp-socket.
Step 5: Replace the cover and screw the handle screw.
Installing
♦ The installation of the device has to be built and constructed
in a way that it can hold 10 times the weight for 1 hour
without any harming deformation.
♦ The installation must always be secured with a secondary
safety attachment, e.g. an appropriate catch net. This
secondary safety attachment must be constructed in a way that no part of the installation can fall down
if the main attachment fails.
♦ When rigging, derigging or servicing the fixture staying in the area below the installation place, on
bridges, under high working places and other endangered areas is forbidden.
♦ The device should be installed outside areas where persons may walk by or be seated.
♦ IMPORTANT! OVERHEAD RIGGING REQUIRES EXTENSIVE EXPERIENCE, including (but not
limited to) calculation working load limits, installation material being used, and periodic safety
inspection of all installation material and the device.
♦ The device has to be installed out of the reach of people.
♦ If the device shall be lowered from the ceiling or high joists,
professional trussing systems have to be used. The device must
never be fixed swinging freely in the room.
♦ Caution: Devices may cause severe injuries when crashing down! If
you have doubts concerning the safety of a possible installation, do
NOT install the device!
♦ DANGER OF FIRE! When installing the device, make sure there is
no highly-inflammable material (decoration articles, etc.) within a
distance of min. 0.5 M.
♦ Mount the device with the mounting-bracket to your trussing system
using an appropriate clamp. The hole in the mounting bracket has a
diameter of 13 mm.
♦ For overhead use, always install a safety-rope that can hold at least
10 times the weight of the fixture. You must only use safety-ropes
with screw-on carabines. Pull the safety-rope through the hole in
the mounting-bracket and over the trussing system etc. Insert the
end in the carabine and tighten the safety screw.
♦ Adjust the desired inclination-angle via the mounting-bracket and fix
the fixation screws.
♦ DANGER TO LIFE! Before taking into operation for the first time,
the installation has to be approved by an expert or by qualified ENGINEERS/TECHNICIANS only!
Connection with the mains
THEATRE 300/500 User Manual/Manual de uso
COVER
HANDLE
SCREW
1.TRUSSING
2.SAFETY-ROPE
3.SCREW-ON
CARABINE
4.SAFETY-SCREW
5.HOOK
Pag 2