Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
!
WARNING!
Failure to follow these instructions can result in fire or injury from excessive heat build up.
Operator is responsible for ensuring cigarette adapter fits correctly into cigarette/auxiliary outlet used.
For proper operation, verify cigarette/auxiliary outlet circuit is rated to supply a minimum of 10 amps. (See specifications
section for rated current in amperes).
Do not exceed the current rating for the cigarette lighter power outlet recommended by vehicle manufacturer.
Keep cigarette lighter adapter and outlet clean and free of debris.
Do not use the cigarette lighter adapter when wet.
Insert cigarette lighter adapter fully into the outlet for proper connection.
Grasp cigarette lighter adapter, NOT cord, to remove from outlet.
Remove cigarette lighter adapter completely from outlet when light is not in use.
Important! Disable power before wiring up the beacon.
Wiring:
The wiring for this configuration is as shown in Figure 3
below. All wiring should be a minimum of 18AWG. The
positive line must have a 5 amp fuse, as shown. A switch
may be used to control the on/off function.
920-0076-00 Rev. G
Figure 3
Figure 2
Light Output & Flash Mode Selection:
All beacons are shipped from the factory set for high inten-
sity and double flash. To change these settings, remove the
lens, locate the DIP switches and set the desired options.
Refer to Figure 4. After setting switches, replace lens and
tighten completely by BOTTOMING out against the base.
Note:
Operating the Beacon without the lens installed on
this product will result in damage that will not be covered
under warranty.
Figure 4
Page 3 of 4
Publicidad
Tabla de contenido
