Placing Tool In Service - Ingersoll Rand 7801 Instrucciones

FAILURE TO OBSERVE THE FOLLOWING WARNINGS COULD RESULT IN INJURY.
WARNING
Always wear eye protection
when operating or perform-
ing maintenance on this tool.
WARNING
Air powered tools can vibrate
in use. Vibration, repetitive
motions or uncomfortable po-
sitions may be harmful to your
hands and arms. Stop using
any tool if discomfort, tingling
feeling or pain occurs. Seek
medical advice before
resuming use.
WARNING
Keep body stance balanced
and firm. Do not overreach
when operating this tool.
LUBRICATION
Ingersoll–Rand No. 10
Always use of an air line lubricator with these tools.
We recommend the following Filter–Lubricator–Regulator
Unit:
For International– No. C28–C4–FKG0
After each two or three hours of operation, unless an air
line lubricator is used, disconnect the air hose and insert 3
or 4 drops of Ingersoll–Rand No. 10 Oil into the air inlet.
Model Type of
Handle
7801, 7801–EU pistol
7806, 7806–EU pistol
H
Tested in accordance with ANSI S5.1–1971 at free speed
♦ Tested in accordance to ISO8662–1 at 80% rated free speed
WARNING LABEL IDENTIFICATION
90 psig
(6.2bar/620 kPa)

PLACING TOOL IN SERVICE

Ingersoll–Rand No. 28
SPECIFICATIONS
Free Chuck Capacity
Speed
rpm in (mm)
2100 3/8 (10)
950 1/2 (13)
WARNING
Always wear hearing
protection when operating
this tool.
WARNING
Do not carry the tool by the
hose.
WARNING
Operate at 90 psig (6.2 bar/
620 kPa) Maximum air
pressure.
MAIN LINES 3 TIMES
AIR TOOL INLET SIZE
TO
AIR
SYSTEM
TO
AIR
TOOL
LUBRICATOR
REGULATOR
BRANCH LINE 2 TIMES
AIR TOOL INLET SIZE
DRAIN REGULARLY
HSound Level
Pressure
77.8
80.2
2
WARNING
Always turn off the air sup-
ply and disconnect the air
supply hose before install-
ing, removing or adjusting
any accessory on this tool,
or before performing any
maintenance on this tool.
WARNING
Do not use damaged, frayed
or deteriorated air hoses
and fittings.
International Warning Label:
Order Part No. ___________
FILTER
COMPRESSOR
(Dwg. TPD905–1)
♦Vibrations
dB (A)
Power
– – –
– – –
Level
2
m/s
0.6
0.5