Soundoff Signal mpower EMPS2QM Serie Manual Del Usuario página 5

with Clear Duty™ Technology
FEED WIRES THROUGH CLIP
REMOVE ADHESIVE
LINER
QUICK MOUNT LIGHT
QUICK MOUNT w/QUICK CLIP STEPS 1 & 2
CLIP OVER EDGE OF VEHICLE
WITH PULL TABS STILL IN PLACE
PULL TABS TO SECURE
TO SURFACE
QUICK MOUNT w/QUICK CLIP STEPS 4 & 5
1.800.338.7337 / www.soundoffsignal.com
5
®
QUICK CLIP KIT
QUICK MOUNT w/QUICK CLIP STEP 3
VEHICLE
SURFACE
QUICK MOUNT w/QUICK CLIP FINAL ASSEMBLY
INSTALLATION:
Quick Mount w/Quick Clip
1. Feed wires through quick clip as shown.
2. Remove adhesive liner on the light and install clip to light.
Make sure to properly align ends before placing down.
3. Route wires into recessed pocket lying flat in pocket.
4. With red pull tabs still in place, clip light over edge of vehicle
surface. Be careful to make sure red pull tabs DO NOT PEEL,
FOLD UNDER OR WRINKLE. Make sure wire is lying
flat and is not pinched.
5. With light properly oriented, pull red tabs to secure light to
ROUTE WIRES INTO
surface.
RECESSED POCKET
6. Make wire connections.
mPOWER 9.16