Soundoff Signal mpower EMPS2QM Serie Manual Del Usuario página 9

with Clear Duty™ Technology
REMOTE MODE: FOR USE WITH bluePRINT SYSTEM ONLY
Connecting the Green wire to ground before applying power to the Red or Red/White wires will place the LED module into remote mode and the light output color will be directly controlled by the input wires as shown below.
For Cruise mode or Low Power control of the LED module, the signal to the control wires must be 100 +/- 2Hz using the duty cycle inputs listed below to produce the light output.
nFORCE Secondary LED Light Remote Mode Functionality
Red/Wht
Red Wire
Wire
Swap=OFF
Cruise - Cruise Color 1
- Cruise
Cruise Cruise
Flash - Flash Color 1
- Flash
Flash Flash
Steady ON - Steady ON Color 1
- Steady ON
Steady ON Steady ON
Cruise Flash
Cruise Steady ON
Flash Steady ON
1.800.338.7337 / www.soundoffsignal.com
9
®
Single Color
Color Color
Swap=ON Swap=OFF
Cruise Color 1
Cruise Color 2
Cruise Color 2
Steady ON Color 1
Steady ON Color 2
Steady ON Color 2
Flash Color 2/Cruise
Color 1 during OFF
cycle of Flash
Steady ON Color 2
Steady ON Color 2
Dual Color
Color Color
Swap=ON Swap=OFF
Cruise Color 2 Cruise Color 1
Cruise Color 1 Cruise Color 2
Cruise Color 1 Cruise Color 3
Flash Color 1 Flash Color 2 Flash Color 1
Flash Color 2 Flash Color 1 Flash Color 2
Flash Color 2 Flash Color 1 Flash Color 3
Steady ON Color 2 Steady ON Color 1
Steady ON Color 1 Steady ON Color 2
Steady ON Color 1 Steady ON Color 3
Flash Color 1/Cruise
Color 2 during OFF
cycle of Flash
Steady ON Color 1
Steady ON Color 1
Tri Color
Color Color
Swap=ON
Cruise Color 2
Cruise Color 1
Cruise Color 3
Flash Color 2
Flash Color 1
Flash Color 3
Steady ON Color 2
Steady ON Color 1
Steady ON Color 3
Cruise Mode Duty Cycle
(@ 100Hz)
Input Light Output
40% OFF
50% 5%
60% 10%
Low Power Flash D.C. (@
100Hz)
Input Light Output
70% 30%
80% 40%
50%
90%
mPOWER 9.16