Tripp-Lite AGOM5516 Manual Del Propietário página 6

Basic Operation (Rear Panel)
6
USB Port
7
Tel/DSL Jacks
8
Coaxial Jacks
17-04-260-932663.indb 6
USB Communication Port: This port can connect your UPS to a
computer in order to automatically save open files and shut down the
computer if it is left unattended during an extended power failure.
Use with Tripp Lite's PowerAlert Software and appropriate USB cable.
A PowerAlert CD and/or USB cable are included with select models. If
PowerAlert is included with your model, insert the CD into the CD tray
of your computer and follow the installation instructions. If PowerAlert
Software and/or the appropriate cable did not come with your UPS,
you can obtain the software FREE via the Web at www.tripplite.com.
Any user-supplied USB cable may be used to connect your UPS to
your computer.
Note: This connection is optional. The UPS will work properly without this
connection. Also Note: This UPS System automatically provides basic
communication compatibility with many integrated Windows
Linux power management applications.
®
Tel/DSL Protection Jacks (select models only): RJ-style jacks
protect connected equipment by stopping surges on a single phone,
fax or modem line. Connect a phone cord from the wall jack directly to
the Tel/DSL jack labeled "IN." Connect a phone cord from the Tel/DSL
jack labeled "OUT" directly to the device to be protected. The UPS
system must always be the first item connected in line from the wall
jack. The UPS system must be plugged into a 3-wire grounded AC
outlet for Tel/DSL line surge protection to work. Connecting your
equipment to these jacks is optional. Your UPS will work properly
without this connection.
Coaxial Protection Jacks (select models only): Gold-plated coaxial
"F" connectors protect connected equipment by stopping surges on a
single DSS satellite, cable or antenna line. Connect a coaxial cable
from the wall jack directly to the coaxial jack labeled "IN." Connect a
coaxial cable from the coaxial jack labeled "OUT" directly to the device
to be protected. The UPS system must always be the first item
connected in line from the coaxial wall jack. The UPS system must be
plugged into a 3-wire grounded AC outlet for coaxial line surge
protection to work. Make sure cables connected to satellite dishes,
antennas, etc. are also grounded. Connecting your equipment to these
jacks is optional. Your UPS will work properly without this connection.
Battery Replacement Door: Under normal conditions, the original
battery in your UPS will last several years. Battery replacement should be
performed only by qualified service personnel. Refer to "Battery Warnings"
in the Safety section. Should your UPS require battery replacement, visit
Tripp Lite on the Web at www.tripplite.com/support/battery/index.cfm to
locate the specific replacement battery for your UPS.
6
, Macintosh and
® ®
4/25/2017 10:46:03 AM