Auto Power Off; Non-Contact Voltage (Ncv) - C-LOGIC 5200 Manual De Instrucciones

4.4 Maximum/Minimum Reading
4.4.1 Press "MAX/MIN" to display the maximum value
recorded
4.4.2 Press "MAX/MIN" again to display the minimum
value recorded.
4.4.3 Hold "MAX/MIN" to return to normal readings.
4.5 Function Switching
4.5.1 In voltage or current modes, press "FUNC" to
switch between AC and DC.
4.5.2 In resistance, diode or continuity modes, press
"FUNC" to switch between measurements.
4.5.3 In temperature mode, press "FUNC" to switch
between ºC and ºF.
4.6 Backlight
4.6.1 Press "-:+: - "to turn on backlight.Press again to turn off.

4. 7 Auto Power off

4. 7.1 lf there is no operation for 15 minutes after turning
the machi ne on, the meter will automatically power
off to save the battery.
4. 7.2 After automatic power-off, press any key to turn the
meter on again.
4.7.3 Holding the "FUNC" key when powering on will
cancel automatic power-off function.

4.8 Non-Contact Voltage (NCV)

4.8.1 With the rotary switch in any position except OF F,
hold down the "NCV" button.
4.8.2 Move the tip of the meter near the voltage so urce
or conductor. lf the voltage detected is greater
than 11 OVAC, the buzzer will beep and the NCV
indicator near the tip of the meter will flash.
15
Note,
1.Even though there is no indication,voltage may still
exist.Do not rely solely on NCV detector to determine
the presence of voltage in a wire.The measurement
may be affected by the design of the outlet, type of
insulation and other externa! factors.
2.The voltage sensing indicator may turn on when a
voltage is fed to the meter.
3.0ther externa! interference(ex.Flashlight,motor)may
trigger the NCV sensor.
4.9 AC/DC Voltage
Voltage is the electrical potential difference between two
points in a circuit. AC polarity changes over time, where
DC polarity stays constant.
Measuring AC or DC voltage:
4.9.1 Move the rotary switch to the "V" position.
4.9.2 Connect the red test lead to the "V" jack and the
black test lead to the "COM" jack.
4.9.3 Connect the test leads to the voltage source or load.
4.9.4 The measured voltage will be displayed.F or DC
voltage, polarity of the red test lead will be
indicated.
4.9.5 Press "FUNC" to switch between AC/DC voltage.
4.1 O Resistance
4.10.1 Move the rotary switch to the
4.10.2 Connect the red test lead to the "O" jack and the
black test lead to the "COM" jack.
4.10.3 Connect the test leads to the circuit.
4.10.4 Resistan ce val u e will be displayed.
"+fb
"position.
16