Items Supplied; Part Identification; Fixing The Kitchen Radio Beneath A Wall Cabinet - Silvercrest KH 2281 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Notice regarding separation from
mains-power
The POWER switch does not completely
disconnect the appliance from the power
network. Additionally, the appliance consumes
power when in standby-mode. To completely
separate the appliance from mains-power, the
power plug MUST be removed from the wall
socket.
Information regarding the handling
of batteries
The appliance uses batteries for memory conservation.
For the handling of batteries please observe the
following:
Risk of explosion!
Do not throw batteries into a fire. Do not recharge
the batteries.
Never open batteries, never solder or weld
batteries.
The risk of explosions and injuries exists!
Regularly check the condition of the batteries.
Leaking batteries can cause damage to the
appliance.
If you do not intend to use the appliance for an
extended period, remove the batteries.
In the event of the batteries leaking acids, wear
protective gloves.
Clean the battery compartment and the battery
contacts with a dry cloth.
Important !
No liability/warranty will be considered for
damage to the Kitchen Radio caused by the
effects of moisture, water penetration or
overheating!

Items supplied

-
Kitchen Radio KH 2281
-
Mounting plate
-
4 Screws
-
Operating Instructions

Part identification

q
Mounting plate
w
Retaining lever
e
Power cable
r
Wire antenna
TIMER/ALARM MODE
t
Button
ALARM 1/VOL+
y
Button
POWER ON/OFF
u
Button
ALARM 2/VOL-
i
Button
1/3 PRESET, 2/4 PRESET
o
Button
a
Battery compartment
s
Display
A.O.T.
d
Button
STORE
f
Button
TUNING UP/DOWN
g
Button
h
Loudspeaker
MODE SET
j
Button
Fixing the kitchen radio beneath
a wall cabinet
With the supplied mounting plate
the kitchen radio below, for example, a kitchen wall
cabinet:
1.
Determine a suitable location for the kitchen
radio.
2.
Press the two retaining levers
the appliance down. Push the mounting plate
q
back and remove it.
3.
Place the mounting plate
lation location. Allow 3,5 cm room to the front
edges. This way the kitchen radio will later fit
flush.
- 28 -
q
you can fix
w
on the back of
q
against the instal-

Publicidad

Tabla de contenido
loading

Tabla de contenido