Home Decorators Collection ALTURA Guía De Uso Y Cuidado página 7

Assembly - Standard Ceiling Mount
1
Preparing for mounting
□
Remove the canopy ring (L) from the canopy (C) by turning
the ring counter-clockwise until it unlocks.
□
Remove the mounting bracket (A) from the canopy (C) by
loosening the two canopy screws (HH) located in the "L
shaped" slots.
□
Remove and save the two canopy screws (SS) in the round
holes. This will enable you to remove the mounting bracket
(A).
HH
3
Assembling the fan
CAUTION: To ensure wobble-free operation and to avoid
damage to the fan, the downrod (B) and the setscrew
(DD) must be completely tightened
NOTE: This fan is equipped with a safety tab (EE). Should
the setscrew (DD) ever become loose while the fan is
running in reverse, the safety tab (EE) will engage and
stop the fan from falling.
□
Loosen, but do not remove, the setscrew (DD) on the collar (FF)
on top of the fan-motor assembly (D).
□
Install the downrod (B) by inserting it into the motor collar (FF),
and turning it clockwise until it is tight.
□
Re-tighten the setscrew (DD) on the collar (FF) on top of the fan
motor assembly (D).
2
Routing the wires
□
Route the wires exiting the top of the fan motor (D) into
the decorative motor collar cover (F) and through the
canopy ring (L).
□
Make sure the slot openings are on top and route the
wires through the canopy (C) and then through the ball/
downrod assembly (B).
A
SS
C
L
DD
7
F
HOMEDEPOT.COM/HOMEDECORATORS
Please contact 1-800-986-3460 for further assistance.
C
L
B
F
D
B
FF
EE
D