Altimeter (Alti); Height; Maximum Alitude - Crivit 1-LD4657 Indicaciones Sobre Su Utilización Y Su Seguridad

Incorrectly performing the calibration can
result in faulty measurements. When
encountering "suspicious" or incorrect
readings, the calibration should be
repeated.
Entering the deviation (declination) to the
geographical North Pole
This deviation results from the calculable
difference between the magnetic North Pole
and the geographical North Pole as used
on maps. The local deviation is printed on the border of geographical maps (the
deviation depends on the latitude). It is shown as a positive east value (E) or a
negative west value (W). When using the map to navigate to a target, the direction
to the target must be adjusted on the map. This is done by subtracting the positive
value or adding the negative value to the shown value.
Press and hold SET to enter the declination mode.
Immediately after entering the setting mode for the
declination, the letter "E" (for east) will blink on the display. Press SEL to select E or
W (for west). Press SET to confirm your selection.
The degree digits will blink on the display. Press SEL to enter the declination and
press SET to confirm your setting.
Because the entered values directly influence the directional indication, they must be
activated by pressing SEL to select " ON" or „ OFF". Confirm your selection by
pressing SET.
Exit setting mode by pressing MODE.
The following examples may help to explain the effect of the deviation:
The direction shown on the display is N10° (10 degress north).
Entering an east deviation (E) of 30 degrees will change the directional indication to
NE (north-east) 40 degrees.
Entering a west deviation (W) of 30 degrees will change the directional indication
to NW (north-west) 340 degrees.
- 71 -

Altimeter (ALTI)

(-999 m - +9999 m / -2999 ft - +29999 ft)
Please note:
atmospheric air pressure. The shown value can vary by up to
50 m because of changing weather- regardless of a change
in location.
We recommend that, before use, the altitude value should be
set with the sports watch on your wrist. Then wait for a few
minutes so that the value can stabilize.
Select the feature by pressing MODE repeatedly. Press SEL to select the different
sub-features.
Altimeter (ALTI) > maximum altitude memory (HIGH) > minimum altitude memory
(LOW) > total altitude gain (UP) > total altitude loss (DOWN) > number of hills
(HILL) > memory (RECORD).

Height

Press SEL to select the sub-feature (ALTI).
Press and hold SET for 3 seconds to enter setting mode. Enter the
desired value by pressing SEL and confirm your setting by pressing
SET.
Exit setting mode by pressing MODE.
Press SET to select the display mode height/time or
temperature/time/diagram/current altitude.

Maximum alitude

Press SEL to select the sub-feature (HIGH).
Your altitude is determined by measuring
- 72 -