marklin GG1 - USA Manual De Instrucciones página 6

Function
• Possible operating systems:
6646/6647 Märklin Transformer, Märklin Delta, Märklin
Digital, Märklin Systems.
• Recognition of the mode of operation: automatic.
• Addresses that can be set (Control Unit): 01– 80.
Address set at the factory: 49.
• Mfx technology for the Mobile Station /Central Station.
Name set at factory: GG1_ 4861
• Adjustable acceleration/braking (ABV).
• Adjustable maximum speed.
• Setting the locomotive parameters electronically with
the Control Unit, Mobile Station or Central Station.
• Built-in sound effects circuit, can only be used in
operation with the Control Unit or Märklin Systems.
Additional sound effects that can be controlled.
• This train is designed for operation on Märklin H0
M, K or C tracks with a minimum radius of 360 mm.
Recommended minimum radius: 450 mm / 17-11/16.
6
Safety Warnings
• This locomotive is to be used only with an opera-
ting system designed for it (Märklin 6646/6647 AC
transformer, Märklin Delta, Märklin Digital or Märklin
Systems).
Use only transformers rated for your local hosehold
!
power.
Do not under any circumstances use transformers
rated for 220 volts or 110 volts
• This locomotive must never be supplied with power
from more than one transformer.
• Pay close attention to the safety warnings in the
instructions for your operating system.
• The feeder track must be equipped to prevent inter-
ference with radio and television reception, when the
locomotive is to be run in conventional operation. The
74046 interference suppression set is to be used for
this purpose.
The maintenance work necessary with normal operation
of this locomotive is described below. Please see your
authorized Märklin dealer for repairs or spare parts.
No warranty or damage claims shall be accepted in those cases where
parts neither manufactured nor approved by Märklin have been installed
in Märklin products or where Märklin products have been converted in
such a way that the non-Märklin parts or the conversion were causal to the
defects and / or damage arising. The burden of presenting evidence and
the burden of proof thereof, that the installation of non-Märklin parts or the
conversion in or of Märklin products was not causal to the defects and / or
damage arising, is borne by the person and / or company responsible for
the installation and / or conversion, or by the customer.