Electrical Connection - Dometic CS 52 Manual Del Usuario

Adjust the feet of the wine cellar so that it stands
in a vertical position in both directions. Use a spirit
level if necessary.
1. Remove the transport pallet on which your
wine cellar rests.
2. Adjust the feet to allow a 0 mm
clearance under the wine cellar.
. Attach the steel rod using the two screws
at the top back on each side of the cellar.
The rod ensures the correct distance to the
wall behind.
4. For optimum performance, please place
your wine cellar far away from any source
of heat (radiator, cooker or intense sun-
light).
5. Check that the charcoal filter is in place at
the top left corner inside the wine cellar.
6. Fit the door handle to the door, see
"Appendix B".
. Attach the driptray on the back. The
screws are already attached at the back.
1
2
3

electrIcal connectIon

It is essential that the electrical installation is car-
ried out correctly, taking into account all relevant
regulations and codes of practice. Your wine cellar
will operate on a mono-phased alternating current.
Please check that the voltage shown on the data
plate corresponds to your power supply.
!
the wine cellar must be earthed.
The wine cellar is fitted with a plug intended for an
earthed socket. Dometic and its subsidiaries will
not be held responsible for any incident due to non-
existent or defective earth wires.
Electrical leads must be routed and secured so
that they cannot come into contact with hot or
sharp parts of the wine cellar.
- 4 -
WARNING