Descargar Imprimir esta página

Sera PRECISION Biotop Nano LED Cube 16 Manual Del Usuario página 8

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 20
US
Instructions for installation and use
sera Biotop Nano LED Cube 16
Please read these instructions carefully and keep for future use. When forwarding this unit to third parties, this
information for use is also to be handed over.
Thank you for choosing the new sera Biotop Nano LED
Cube 16.
This stylish nano aquarium with a volume of 16 l
(4.2 US gal.) is equipped with filtration and lighting for
operation in freshwater. The generously dimensioned fil­
tration along with the filter media considerably contrib­
utes to the biological stability of the nano system and
to lasting aquarium fun. The included modern 12 V LED
lighting can be adjusted to the requirements of plants
and animals by a dimmer, and achieves a particularly ad­
vantageous energy efficiency.
Besides saving energy you will also benefit from the long
lifetime of the LED chips. Lamp replacement is no lon­
ger required every year, and even single LED units fail­
ing hardly affects brightness in the aquarium. The light­
ing can still be operated without any problems until the
faulty LED unit has been replaced.
Due to its bow front without silicon seams, the sera
Biotop Nano LED Cube 16 has the well proven three­
side appearance. This allows watching the aquarium in­
habitants easily. The transparent cover allows light to
enter through the middle gap without any reflection, but
at the same time reduces evaporation.
General notes
• Please read these instructions and those of the includ­
ed carefully sera Nano LED light and keep for future
use. Also, please check your sera aquarium for com­
pleteness.
• Please switch off all submerged technical devices by
pulling their mains plugs before touching the water
with your hand.
The aquarium and the sera Nano LED light are opti-
mally packed. However, damages due to long range
transport may have occurred, as is the case with all
glass products. Therefore please check whether the
glass is in order before filling the aquarium for the
first time.
Kit includes
Plug-in complete equipment
ready to start
Aquarium with bow front (1.1)
Polished glass
Volume c. 16 liters (4.2 US gal.) W 22 cm x H 30 cm x
D 25 cm (8.7 in. x 12 in. x 10 in.) [Height with sera Nano
LED light approx. 39 cm (15.3 in.)]
Transparent cover (1.2)
sera Nano LED light with ballast (1.3)
3 chamber internal filter (2) with
• Intake grid (2.1)
• Intake chamber with large filter sponge (2.2)
• Upstream duct (2.3)
• Filter sponge, small (2.4)
• sera siporax mini Professional for the biological
filtration with sera filter media bag 1 (2.5)
• sera filter pump FP 150 (2.6, 3)
• Hose connection to spray bar (2.7)
• Curve pipe for connection to spray bar (2.8)
• Spray bar (2.9)
sera siporax mini Professional filter medium
sera filter biostart filter starter (1.4)
sera super carbon filter medium
sera shrimps natural, granulate for shrimps
sera aquatan for water conditioning
This part of the information for use refers to operation of
the glass tank with internal filter and pump.
Please read the according information for use for operat­
ing the included devices.
Lighting:
sera Nano LED light (separately packed with descrip­
tion and instructions for use)
Assembly and operation
Location:
Place the sera aquarium in a suitable location. Depending
on the internal decoration, the aquarium may weigh up to
25 kg (55 lb.). Therefore, the chosen location should be
perfectly even (best use a spirit level for balancing). Of
course, a mains supply should be available nearby. If you
wish to place it on an already existing piece of furniture,
it must provide sufficient carrying capacity.
The aquarium should by no means be placed near a
sunny window. Too much sunlight does not only heat
up the aquarium too strongly, but may also cause
algae blooms. The sera Biotop Nano LED Cube 16 is
equipped with a glued­on safety frame. Place the aquar­
ium with its frame directly onto the cabinet. Do not use
any additional mats.
The setup location should be 20 – 25°C (68 – 77°F)
warm. In case of lower temperatures and depending
on the animals kept, a heater (not included, for instance
sera aquarium heater thermostat 25 W) should be
used. A heater can be placed in the third chamber if
required.
8

Publicidad

loading