Bayside Furnishings MARCD-PC-N Instrucciones De Montaje página 7

5. Ask for assistance to lift the unit upright and position at the desired location. If necessary, adjust the
pre-attached Floor Levelers at the bottom of the legs to level the unit.
6. The integrated power center is pre-attached inside the left utility drawer for your convenience. Route
the wires through the installed Cord Clips (EE) for less tangled mess. Plug the power center into a
properly grounded outlet.
7. You can flip down the center drawer front to convert it into a keyboard tray. If you need to remove
the pullout drawer, please pull the drawer all the way out, then simultaneously push the plastic release
lever of the ball bearing slide up on one side and down on the other side, and then pull the tray
completely out.
NOTE: To place the drawer back, simply push the ball bearing cart all the way to the end of the
slides (in both sides), and align the slide runners on the drawer with the slide tracks on the unit and
push it carefully inside until it stops. If the drawer does not go in smoothly, please take it out and
repeat the step.
Assembly Instructions
B
7
A
B/C
C
E