Publicidad
Idiomas disponibles
Idiomas disponibles
4.
Thread two carriage bolts through the holes on the left side of
the rear support bracket and thread on two flange lock nuts
until finger tight. See inset in Figure 4. Repeat this process on
the right side. See Figure 4.
5.
Carefully thread the two remaining carriage bolts through the
two holes at the rear base of the mower frame and the rear
support bracket. Thread on the two remaining flange lock
nuts. See Figure 5.
6.
Securely tighten all carriage bolts and flange lock nuts from
steps 4 and 5.
Figure 4
Figure 5
ASSEMBLY
7.
Follow steps below to assemble the grass bagger. Make certain
the bag is turned right side out before assembling (warning
label will be on the outside).
a.
Place bag over frame so that its black plastic side is at
the bottom.
b.
Slip plastic channel of grass bag over hooks on the
frame. See Figure 6.
Attaching Grass Bagger Chute
1.
Remove the vinyl cap on the deck stud in front of the discharge
opening. See Figure 7.
9
Figure 6
Figure 7
Publicidad
