Care And Cleaning - Symmons Temptrol Instrucciones De Instalacion, Operacion Y Servicio

bACK To bACK InSTALLATIon
To simplify piping on back to back installations use one stan-
dard valve (hot on left, cold on right) and one with reverse
coring (hot on right, cold on left) as shown in Figure 6 and
7. Order reverse core valve by adding the suffix reV-X
after the plate number. (e.g. S-96-2-REV-X Temptrol
shower unit with reverse coring.)
fIGure 6
HOT
COLD
oPerATIon of VALVe
The main handle of the Temptrol valve is for control of
temperature only. From the OFF position, the handle is
turned counter-clockwise through a minimum cold position,
through a warm and hot position for a maximum turn of
approximately one revolution. This allows for wide range of
temperature adjustments to suit the requirements of the user.
model A (tub and shower) is equipped with a combination
diverter and volume control. The small lever handle below
the temperature control handle can be moved to the left for
tub flow and to the right for shower flow. For volume reduc-
tion in either tub or shower position, move the small lever
handle below the temperature control handle slowly toward
the center or vertical position to obtain the desired reduction
in water volume.
model b (shower only) is equipped with a built-in volume
control. The small lever handle below the temperature
control handle can be moved from left to right to obtain a
reduction in water volume.
model C (tub or shower) does not have the added feature
of volume control built into the valve.

CAre And CLeAnInG

The lustrous finish on your Temptrol valve should be treated
with care. It can be readily damaged by improper handling or
abusive treatment. To clean the finish wipe gently with a soft
damp cloth and blot dry with a soft towel. Use only a mild
soap solution if required. do noT uSe AbrASIVe CLeAn-
erS. uSe of PoLISh, AbrASIVe CLeAnerS, SoLVenTS
or ACId CLeAnerS wILL dAmAGe The fInISh And
VoId The SymmonS wArrAnTy.
fIGure 7
back to back Installation
® tub and
1
''
3
8
79mm
shower
discharge
STANDARD
VALVE
hot and cold
inlets
HOT
3
''
2
8
60mm
COLD
5
2 ''
8
67mm
tub discharge
fIGure 8
Seat removal Tools
FOUR BROACHED
NOTCHES TO
ENGAGE FOUR
CORNERS
OF HOT SEAT
TOOL.
Page 4
1
6 ''
4
159mm
MINIMUM WALL
THICKNESS
1
+ ''
2
1
''
+
2
1
+ ''
2
NOTCH
EIGHT BROACHED NOTCHES
TO ENGAGE FOUR CORNERS
OF COLD SEAT TOOL IN TWO
POSITIONS.
1
'' 13mm
2
REVERSE
CORE
VALVE
COLD
T-35A
T-35B