Controlling The Rock Master; Trimming - THINK GIZMOS ROCK MASTER TG631 Manual Del Usuario

3. CONTROLLING THE ROCK MASTER

3.1 Controlling the Rock Master
In order to make the Rock Master travel forward, hold the contoller in your hand and pull the
●
accelerator trigger switch towards you. The Rock Master will begin to travel forward.
● In order to make the Rock Master travel in reverse, hold the controller in your hand and push the
accelerator trigger away from you. The Rock Master will begin to travel backwards.
● Releasing the trigger at any time will result in the Rock Master coming to a complete stop.
To make the Rock Master turn you will also need to turn the steering control at the same time as
●
pulling or pushing the accelerator trigger.
We advise holding the Remote Control unit in your left hand and control the steering wheel with
●
your right hand.
● When travelling forwards, turn the steering control in a clockwise direction to turn right and anti-
clockwise direction to turn left.
● When travelling in reverse, you will need to turn the steering control in the opposite direction.
E.g. to turn the Rock Master right you will need to turn the steering control in an anti-clockwise
direction.

3.2 Trimming

It may be necessary to fine tune
●
the steering via the "Fine Tuning"
adjustment module, located on the
underside of the Truck.
If while travelling in a straight line
●
you find that the Truck strays to the
left or right then you will need to
adjust the steering control to correct
this issue.
It is best to make several small
●
adjustments to the steering this
allows for an accurate adjustment of
the steering.
If the Truck strays to the left then
●
you will need to move the steering
adjustment to the right (R).
If the Truck strays to the right then
●
you will need to move the steering
adjustment to the left (L).
5