Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
9. Press the Start Button; the Indicator Light will illuminate, verifying
that the Coffeemaker is operating.
CAUTION: Do not open the Water Reservoir Lid during the brew
cycle, as scalding may occur.
10. Allow all the coffee to drip from the Brew Basket into the Travel
Mug before removing the Travel Mug.
NOTE: Since coffee grounds absorb some water during brewing,
the amount of brewed coffee will be slightly less than the amount of
water poured into the Water Reservoir.
11. When the brewing cycle is complete, the Indicator Light will shut off
and the unit will no longer heat.
12. If brewing another Travel Mug of coffee at this time, proceed to the
"Brewing a Second Mug of Coffee" section.
13. When all brewing is complete, unplug the Power Cord from the
electrical outlet.
NOTE: The Start Button on this product is a
thermally-operated activation switch for starting a
brewing cycle. Pressing it again after the start of a
brewing cycle will not stop the product from
operating. To interrupt a brewing cycle, unplug the
product from the electrical outlet. If the Indicator
Light comes "ON" when the product is first plugged
in, wait approximately 30 seconds for it to go "OFF"
before using the product.
Brewing a Second Mug of Coffee:
To brew another Mug of coffee, allow the Coffeemaker to completely
cool (about three minutes) after the Indicator Light has shut off. Rinse
the Mug and the Reusable Mesh Filter with water. Repeat the brewing
procedure.
WARNING: If the Coffeemaker does not cool completely before reuse,
water placed in the Water Reservoir may overheat. This can cause
steam to escape, resulting in a risk of burns and/or personal injury.
7
Publicidad
Tabla de contenido
